Home > Error Code > Electrolux Icon F30 Error

Electrolux Icon F30 Error

Contents

Frank // Feb 27, 2015 at 5:51 pm Hi Gene, You helped me back in November with a F10 error. My wife is suspicious of the temperature, however. steve // Dec 2, 2014 at 11:44 am hi gene PLEFMZ99ECC used to get f30 but now getting F7 12 and the front element wont turn off - any ideas ? Any ideas. navigate here

Please try the request again. Gene. The part number for the EOC is 316560118 You can order it by clicking on the part number. The part number for the oven relay board is 316443920 The part number for the EOC is 316576601 Good luck. http://www.askgene.com/2013/04/14/oven-error-codes/how-to-fix-frigidaire-of-electrolux-range-or-oven-with-an-f-error-code/

F11 Error Frigidaire Oven

The black potentiometer should have a resistance of 10KΩ. The part number for the door hinge is 318024749 Good luck. I would not tell them it happened due to bad weather. James // Dec 21, 2014 at 11:14 am hi Gene i have a frigidaire stove that is showing an f11 code.

Gene. Of the two in the back, one was model TX22, where the second "2" means that thermostat should be normally open and isn't on the same circuit as the therometer probe creeps up about 20-50 degrees over the setpoint; but the display still shows the correct temp. Frigidaire Oven F31 Error If you would like to replace it too, I need one more letter from the model number to get the correct part number for you.

It is producing the F10 error code at room temperature/day time mode. Frigidaire Stove Error Code F10 I got the code f11 and it won't stop beeping. sergio // Mar 1, 2015 at 6:28 pm I keep getting a code f10 i replaced the eco on my oven.part 316455410 about three months.the problem was fix .now I have Gene.

If the reading is still incorrect, the RTD would need to be replaced. F11 Error Code Electrolux Range The potentiometer is the control for surface element. Gene. It can be easily determined by the model number, usually located on the frame behind the bottom drawer or on the oven door frame.

Frigidaire Stove Error Code F10

The EOC part number 316455400 Thank you for your question. my company The cause of the problem can be a failed lock motor switches or a failed EOC. F11 Error Frigidaire Oven It was the larger ribbon connector on the right. F30 Error Code Frigidaire Range Hello, I hope you mean error code F3.

The problem with a warranty under the lemon agreement is that the failures must be verified by a technician. check over here This error code means it was detected a shorted key on the keypad. I pressed the cancel button, but the error comes back. Thank you, Gene. Electrolux Oven Error Codes

Perform the steps one at a time in the order listed below to correct the specific failure condition. To test the resistance value of either potentiometer make sure that the shaft is set to the off position, disconnect the wire harness and use an ohmmeter to measure the resistance In order to provide most accurate advise I need the complete model number of your oven. http://dssoundware.com/error-code/electrolux-e21-error.php The lower oven has no issues.

Thank you for your question. Electrolux F11 Beeping MML // Mar 31, 2015 at 4:09 pm Hi Gene, Thanks so much for your reply. replaced EOC.

Happy holidays!

Generated Sun, 09 Oct 2016 23:49:58 GMT by s_wx1131 (squid/3.5.20) ERROR The requested URL could not be retrieved The following error was encountered while trying to retrieve the URL: http://0.0.0.9/ Connection This in turn will clear the controls memory of any irregularities it may have received from the power supply. F4 or F31 - Shorted sensor (RTD probe) connection. Frigidaire Eoc The control panel back light will not turn off.

Disconnect the broiler igniter wires and check for continuity between each wire coming to the igniter and the chassis. The part number for the EOC is 316557115 Good luck. The part number for the EOC is 316557205 The part number for the overlay is 316419303 Good luck and keep us posted. http://dssoundware.com/error-code/electrolux-e35-error.php Results 1 to 3 of 3 Thread: PLES389ECH Range - F30 Error - Difference between themostats?